ARRICAM Lite Quick Guide 01/2004, Page 11 of 20
Changing fps
Fps is set on the Standard Camera Control Panel by pushing the FPS selector buttons with a small pointed tool
while the camera is in standby. Fps is set on the Extended Camera Control Panel by first pressing and holding
the UNLOCK button then using the FPS selector buttons while the camera is in standby.
Note:
Before entering the desired fps on the Camera Control Panel, ensure that no other component has control
of the camera, e.g. if the Speed Control Box is attached, its SPEED CONTROL switch has to be set to OFF. Simi-
larly, if the Manual Control Box is connected to the camera, its MANUAL CONTROL switch has to be set to OFF
or to SHUTTER .
Changing shutter angle
To change the shutter angle with the Standard Camera Control Panel, press the SET shutter angle selector with
a small pointed tool. On the Extended Camera Control Panel, it is necessary to press and hold the UNLOCK
button while pressing the SET shutter angle button.
With either panel, each pressing of the SET shutter angle button will cycle through following values:
180°, 172.8°, 150°, 144°, 135°, 120°, 105°, 90°, 86.4°, 75°, 60°, 45°, 43.2°, 30°, 22.5°, 11.2°.
Note:
Before entering the desired shutter angle on the Camera Control Panel, ensure that no other component has
control of the camera, e.g. if the Manual Control Box is attached to the camera, its MANUAL CONTROL switch
has to be set to OFF or to FPS. If the SCB is connected to the camera, make sure its COMPENSATION switch is
set to OFF or to IRIS.
Basic Camera Operations
RAW STOCK
button
UNLOCK
button
SET shutter
angle selector
BRIGHT button
RUN/STOP
button
RUN LED
FPS selector
FPS display
SHUTTER
angle display
PHASE button
Film length (EXPOSED FILM) display
RESET button
FPS selector
Film length (FOOTAGE) display
RESET button
SET shutter
angle selector
FPS selector
FPS display
SHUTTER angle
display
RUN/STOP
button
RUN LED
PHASE
button
Battery (BAT)
LED
Lite Standard Camera Control Panel
Lite Extended Camera Control Panel
