5
Installation
Insert the plug on the free end of the Communications Cable into the
appropriate connector on the host as below described:
Cable Connection:
1.
Please switch ON and charge scanner for 4~5 hours at first time before use,
scanner switch shown on Fig. 2.
2.
After switch ON, the Orange LED will flash following with 3 beep-sounds. The RED
LED will be OFF while it links to cradle within 2.4GHz radio range.
3.
If RED LED is continual ON, please re-plug USB cable, then, scan the 3 barcodes
on the bottom of cradle sequentially. (Shown on Fig. 3 from 1 to 3). If you are
unable to complete this setting within 1 minute, please re-plug USB cable & re-start
the scanner, and try again.
4.
Charging issue: Cradle works as charger when putting scanner on it. Even if the
scanner's battery is full, the cradle will continue to supply power to the scanner.
We suggest you to remove scanner from cradle when scanner is charged fully.
