USE & CARE MANUAL
PK-4102 (Rev 2)
Page 3
Speed level buttons
: these buttons will allow you to choose one of the 4 the speeds of your fan for your
convenience. When choosing a speed, a screen like the one below will display the selected value. After a few
seconds, the main menu will appear again.
Light button
: This button will switch your light intensity through 3 levels from level 0 (or off) to the level 3
(max). To turn off the lights, press the button until the level 0. When you push the light button the display will
show the following message depending of the chosen light level:
Delay button
: This button will allow you to activate and adjust the timer from 5 to 30 minutes. To use it,
simply press this button when the fan is running. The timer begins to decrement and you can follow state, on
the main screen. To increase the timer, press repeatedly until the desired value.
Filter maintenance
To make your hood ventilation efficient, it’s important to clean the filters frequently. This hood is provided
with a filter clean reminder system. After 50 hours of use, the display will show the message “ CLEAN FILTERS”
reminding that you should clean your filters. The filters are made in stainless steel and can be washed by
hand or in the dishwasher.
To remove the filters:
-
turn off the fan and the light
-
Pull the spring release handle
To reset the counter, press and hold the “off” button until
this message disappear.
Replace lights
Warning
Prior to change the light, switch power
off at service panel to avoid any risk of
accident. Allow the light cool, before
handling.
To replace the lights follow the following steps:
-
Remove the inner lamp lens cover by inserting a small flat blade
screwdriver into each of the three slots and gently prying it free.
-
Grasp the bulb and pull it straight out.
-
Replace with 12 volt, 20 watt halogen bulbs with a G4 base.
-
Replace inner cover by inserting the three retaining tabs into the
three slots and pressing them firmly in place.
1
2
