BEFORE FIRST USE & HOW TO CLEAN
1. Remove all packing materials and make sure that the product has been received in
good condition.
2. Wash the stainless steel water tank with warm, soapy water using a sponge or
dishcloth.
3. Rinse out the stainless steel water tank thoroughly to remove any soapy residue.
4. With a damp cloth, gently wipe off the exterior of the water dispenser. Do not wipe
electrical components as this may cause damage to the unit.
5. Dry all parts completely.
6. It is recommended to run your water dispenser through one boiling cycle
before using it to consume beverages.
Following the instructions in TO HEAT
WATER on
page 5
, boil a full tank of water. When water has boiled, pour it out and
rinse the inside of the water tank once more. The water dispenser is now ready for use.
• Do not use abrasive cleaners or scouring pads.
• Do not immerse the appliance, cord or plug in water at any time.
• If you live in an area that has hard water, the stainless steel water tank may discolor
slightly. To remedy this, mix a solution of lemon juice and water, filling the stainless
steel water tank up to the FULL mark. Boil water and let soak for one hour. Repeat
cleaning instructions to remove any lemon juice residue.
Before using for the first time, it is recommended to clean the interior of the water
dispenser thoroughly. Please follow the procedures below before using:
Always unplug the unit and allow it to cool completely before cleaning.
For easier cleaning and filling, the lid of the Digital Water Heater & Dispenser may be
removed. To remove the lid:
4
NOTE
Figure A
Figure B
REMOVING THE LID
1. Press down on the lid release button ( Figure
A
)
2. While holding down on the lid release button, open
lid at a 45° angle and pull toward the front of the
applicance. (Figure
B
)
3. To replace the lid, position it back into place while
holding down the lid release button.
4. Once the lid is in place release the lid release button.