8.
Hot water
1. Flllow steps 1-3 in
Brewing Espresso
page 8.
2. Place your mug underneath the
Steam Wand
.
3. When the
Brew Key
is solid red, the espresso
machine is ready to make hot water.
NOTE:
the
green
Steam Key
should NOT be pressed; make
sure it is not illuminated.
4. Turn the
Control Knob
to
STEAM
. Hot water will
begin pouring from the
Steam Wand
.
5. When desired amount of hot water has been
reached, turn the
Control Knob
back to
O
.
6. Turn the espresso machine off when finished.
Brewing Espresso
1. Plug the espresso machine into an available 120V
AC wall outlet.
2. Turn the
Power Switch
to the
ON
position.
3. Press the
Brew Key
. It will blink red while it heats.
4. While the espresso machine is heating, put the
desired size
Shot Cup
into the
Portafilter
. Press
firmly into place.
5. Use the scoop to fill the shot cup with fine coffee
grounds. Use the tamper side of the
Scoop
to
compress the coffee grounds. Scrape off any
overfill.
6. Insert the
Portafilter
into the espresso machine
and twist right until secure.
7. Place your coffee cup under the
Portafilter
spout.
8. When the
Brew Key
is a solid red, the espresso
machine is ready to brew.
9. Turn the
Control Knob
to
BREW
. Espresso will
begin brewing. Once you have the desired
amount, or the water stream becomes less dark
and clear, turn the knob back to
O
.
10. Remove your cup. Twist the
Portafilter
to the left
and carefully remove. Discard the used coffee
grounds, then clean according to
Cleaning
Instructions
page 6.
11. Turn off the espresso machine when finished.
Caution:
Be careful when using
the
Steam Wand
for hot
water to avoid burns
from spraying.
Summary of Contents for AEM-810
Page 10: ...10 Notes...
Page 12: ...To Enhance and Enrich Lives w w w A r o m a C o c o m...
