- How to change the trimmer line
- If the line doesn’t come out
YES
NO
Changing the trimmer line is a simple operation. Be sure you use a quality trimmer line, otherwise your line will break often
and create unnecessary hassles. We recommend you use our
MAXI-LINE
- a high resistant line which not only increases the
effectiveness of the brush cutter head but also eliminates any chance of the line getting stuck together.
This can be caused by any of the following reasons.
• Has the line been wound up correctly, without crossing over (fig. 6)?
• Once the outer reel was replaced, did you pull and remove the lines from the retainer slits (fig. 9)?
• Is the trimmer line used of poor quality?
• Is it blocked because the knob is dirty?
Remember that proper maintenance and an occasional cleaning of this tool will not only prolong its' life but also prevent product failure.
Caution
For maximum operator safety, before starting work, in addition to the
deflective shield, we recommend you wear a face shield, one of many
quality accessories offered by ARNETOLI MOTOR.
YES
NO
1
Unscrew the bottom part of the
head using the apposite wrench
2
Take off the outer reel
3
Insert the lines in the inner
retainer holes
4
Reel the same lines in the middle of
the spool and wind
5
Overturn the spool and wind up in the direction
as indicated by the arrows on the side
6
The lines must be wound up parallel with each
other and must not cross over each other
7
When finished rolling up the line, place the
line in the retainer slits to keep it from unra-
velling (its recommended to leave at least
4 inches of line to ease step number 8)
8
Re-insert the outer reel on the
housing
9
Once the line is in place, pull the lines
outwards to release them from the slits
ARNETOLI MOTOR S.R.L.
- Via Ponte all’olivo - 50066 Reggello (FI) ITALY Tel. +39. 055. 863484 - Fax. +39. 055. 863485 - e-mail: [email protected] - www.arnetolimotor.it
