Operation
Set description
ь
Y
our
flashlight
can inconsiderably differ from the pictures in the manual.
ь
The producer reserves the right to change the package at his own discretion without modifying this manual
.
Initial Service
Wizard
To set/replace batteries:
1.
Unscrew the tailcap.
2.
Place the batteries with the positive contact (+) facing the head of the flashlight.
3.
Adjust the tailcap and tighten it as far as it can go.
The flashlight is ready for operation.
x
2
1.
1.
2.
2.
3.
To use the
head mount
with the
flashlight:
b.
e.
c.
Pass the ends of
the big
strap through
the loop of the
small
strap and slots in
the silicone holder (fig.
b
), conjoin
them in a ring (fig.
c
). Pass the loose
end of the
big
strap through the loop of
the
small
one in the opposite direction
and fix it in the buckle (fig.
e
).
Connect
the
small
strap
with the
silicone holder.
Fix the
flashlight
and
adjust the
elastic bands
to the size
of your
head.
3.
d.
a.
b.
e.
c.
Items included in the package:
1 -
Flashlight
2 -
Clip
3 -
Headband
(2 straps)
4 -
Silicone holder
5 -
2 spare O-rings
6 -
User manual
1
2
3
4
5
6
Click x1
OFF
в
Main (if last used)
Main
Press & Hold
OFF
в
Firefly1
в
Firefly2
Firefly
Any mode
в
Turbo
Turbo
в
Last mode
Click x2
Turbo
Main1
в
Main2
е
з
Main3
Press & Hold
In OFF state:
Click: To turn on the last used mode.
Press and hold: To go through 2 Firefly modes (release to select). Keeping button pressed will start cycling through the Main modes.
In ON state:
Click: To turn off the flashlight.
Press and hold: To start cycling through the Main modes.
Double click: To turn on the Turbo mode. The second double click brings back the last used mode.
For comfortable operation you have a convenient momentary access to all the following modes:
Main.
Short click from OFF-state activates the Main mode (if
it was the last mode used previously).
Firefly.
Press and hold the button in OFF-state to turn on the
desired Firefly mode and then release immediately. Keeping
the button pressed will start cycling through the Main
modes.
Turbo.
The mode is activated by double click in any mode. To
return to the last mode make double-click again.
Cycling through the Main modes.
In ON-state press and hold
the button (in any mode): the 3 Main modes will start
switching cyclically. Release the button to select the desired
mode.
In Turbo mode it starts cycling through the Main
modes.
Automemorizing.
After switching off the last used Mode is memorized for quick 1-click access at next switching on.
Lock-out function.
Unscrew the tailcap to 1/4 for the protection from accidental switching on.
Low Battery Indication.
If the brightness is <25% from the nominal value, the LED flashes 2 times
ONCE (after 30sec from switching on). If you are not sure if it flashed or not switch the flashlight
off and on: in case the battery is low flashes will repeat. Light output decreases to Firefly mode at
critical level.
Active temperature control.
T
he flashlight
can quickly heat up
in
Turbo
mode
. W
hen
the
temperature become +60
°
C –
the brightness decreases by
small steps
. After cooling-down
(
provided that battery voltage is sufficient
)
the brightness increases to the
Turbo
mode again.
This stepping goes cyclically to maintain the user's safety and the flashlight's functionality. In
conditions of good air-cooling the flashlight delivers light
without stepping down
even in
Turbo
mode. There are no preset timers for stepping, but real-
time
active temperature measurements.
Warning
Low Battery Indication
Critical
в
Firefly1
в
OFF
Cycling through Modes
We DO NOT RECOMMEND to leave power sources inside the flashlight for a long storage period, as batteries (especially, non-rechargeable) can
leak for various reasons and damage the inner parts of the flashlight. If you want to keep your flashlight in a stand-by state with batteries in
then
use
new and
high-
quality batteries
and
store the flashlight in acceptable for batteries operational temperature and revise the batteries' state at least
once a month. If you have noticed any signs of batteries' defects
then
withdraw them from the flashlight and utilize. It is also recommended to
replace discharged batteries with new ones before the storage as the chance of leakage is higher with discharged batteries.
