3
WIZARD C2 WUV USER MANUAL
ENG
REV_00-0000
Initial Service
TO SET/REPLACE BATTERY
1. Unscrew the tailcap.
2. Place the battery with the positive contact (+) facing the head of the
flashlight.
3. Adjust the tailcap and tighten it as far as it can go.
The flashlight is ready for operation.
HOW TO CONNECT THE MAGNETIC CHARGER
Unscrew the tailcap to 1/4 of a circle and adjust the magnetic charger
to the tailcap.
CHARGER COLOR INDICATION
Charger not plugged in:
• Green — device is in waiting mode.
Charger plugged in:
• Green blinking — evaluation of battery voltage.
• Red blinking — unscrew the tailcap to 1/4 for charging.
• Orange blinking — USB power source voltage is too low for correct
continuation of charging or bad contact between charger and battery.
Clean the tailcap and the threads of the flashlight parts, use a differ-
ent power source.
• Red — charging with rated charging current is going on.
• Orange — USB power source voltage is too low, charging current may
be reduced.
• Green — charging is finished.
Operation
Before use:
Tighten the tailcap as far as it can go.
In OFF state:
1 click: To turn on the last used mode.
Press and hold: To turn on Firefly mode of the last used light. Keeping
button pressed will start cycling through modes of the chosen light.
Release to select.
In ON state:
1 click: To turn off the flashlight.
Press and hold: To start cycling through modes of the chosen light.
Release to select.
2 clicks: To change between white and ultraviolet light in any mode.
Add/Remove Strobe modes.
Unscrew the tailcap to 1/4 while the
flashlight is off, press the button, tighten the tailcap while keeping the
button pressed and then unscrew it again.
Automemorizing.
After switching off the last used mode is memorized
for quick access at next switching on.
Active temperature control.
When the temperature of the flashlight
becomes close to +58 °С, brightness decreases to safe value, allowing
the flashlight to avoid overheating for a long period of time. In condi-
tions of good air-cooling the flashlight delivers light without stepping
down.
Low battery level.
When the brightness is approximately <25% from
the nominal value, the LED will flash 2 times. If you are not sure wheth-
er or not it flashed, switch the flashlight off and on: in case the battery
is low, the flashes will repeat after 30 sec from switching on. At critical
level light output decreases to Firefly mode.
Lock-out function.
Unscrew the tailcap to 1/4 for protection from
accidental switching on.
Warnings
For effective operation of the flashlight we recommend branded 18650
Li-Ion batteries without PCB (unprotected) no more than 70 mm long.
The flashlight can get hot in Turbo and Strobe modes quickly and
discharge the battery with high current. Don’t leave it without your
attention as very bright light might heat objects and cause fire.
