Armstrong Brain Wave, Hardware & Software Installation

Page: 23 / 24

23
VALVE CALIBRATION
Caution! The valve must be calibrated, if the mixing valve assembly or the control pcb are replaced. The calibration
number is required and this will be found on the mixing valve body.
(09,
Enter calibration number.
Aim the Programmer at the Control Panel and tap “ Write ”.
&DOLEUDWLRQ
&KDQJLQJ9DOYH&DOLEUDWLRQ
Valve Calibration
Calibration No.
Read Write
Cancel OK
Read Write
Valve Calibration
This will affect the valve
performance.
Please ensure 180 matches
the value printed on the valve
body.
The calibration number will not
be stored until “ OK ” is tapped.
ERROR MESSAGES
Control Panel not disabled or Programmer not aimed at Programming window.
Lost connection during
communication.
Failed to connect
Please try again
Or
Control panel
not Ready
Lost Connection
Yes No
Do you want to Write the
changes to the valve
Warning
Disinfection not enabled
Check that “ Disinfection ” is
checked. Refer to “ Setting
Disinfection: Step 2,
Outlet Setup
”.
‘Service Flush’ in Valve Setup
must be checked to
enable this function
Check that “ Service Flush ”
is checked. Refer to
“
Setting Service Flush:
Step 1, Valve Setup ”.
‘Disinfection’ in Valve
Setup must be checked to
enable this function
Check that “ Disinfection ” is
checked. Refer to “ Setting
Disinfection: Step 1, Valve
Setup
”.
Check that “ Write ” is
tapped.
Refer to “
Setting Outlet
Temperatures ”.
Cancel
Warning
Warning