Arm's Reach Co-Sleeper Versatile, Instruction Manual, Page: 5 / 17

D
F
Step 3 Locking the Sleeping nest (C) to
the Left and Right brackets (D & F)
:
Note: If the plastic receiver does not fit over
the side bracket, turn the Sleeping nest to
the opposite side.
How to assemble bassinet
5
Step 4
How to adjust the height of bassinet
Note: The digital marks on the back of
brackets (D & F) indicate heights as Fig.1.
The Left and Right brackets must be adjusted
to the same height before use.
Never adjust bed height with your baby in
the bassinet.
NEVER USE this product with two different
side heights or creating an incline sleep
position. Always check the digital height
adjustment numbers to ensure the Sleeping
nest is at even surface. Failure to do so
could result in serious injury of death to the
infant.
B
A
D
C
G
9
8
7
6
10
Fig 1 .
Fig .
2
F
Fig 1 .
Fig .
2
Place plastic receivers (Fig. 1) of Sleeping nest (C)
into top end of the side bracket (D & F). Use phillips
screwdriver and Screws (H) provided to secure the
sleeping nest with the bottom frame (Fig. 2). Secure
screws tightly.
Place Mattress with sheet (B) into Sleeping nest.
Install the Mobile (A) into plastic holder on top rail
of sleeping nest.
To raise the height, step on center of the Foot
stablizing bar (G) to stabilize the bassinet, while
holding both sides of sleeping nest rail to pull up to
the desired bed height.
To lower the bassinet, locate the Plastic handles (J)
on Left and Right brackets (D&F) as Fig.2. Pull both
handles up with fingers at the same time to release
locks, continue to push the Sleeping nest (C) down
to the desired height. Check the digital indicators
on the bracket (D & F) that the Left and Right sides
are even.