www.armano-messtechnik.com • p. 15 of 20 • GB • 09/22 • B75 •
B08-590
Operating Instructions
PAXd – Display
[53] enter sensor 1 configuration menu
enter sensor 2 configuration menu
enter CJC sensor configuration menu
enter output loops configuration menu
[54] restore default settings
perform process calibration
[55] enter the value for the lower calibration point
[56] enter the value for the upper calibration point
[57] simulate sensor 1 input
simulate sensor 2 input
simulate CJC sensor input
simulate average measurement
simulate differential measurement
simulate output current loop
[58] set simulation value sensor 1
[59] set simulation value sensor 2
[60] set simulation value CJC sensor
[61] set simulation value average measurement
[62] set simulation value differential measurement
[63] set simulation value output current loop
[64] edit the long tag number ?
[65] edit the tag number ?
[66] edit the description ?
[67] edit the message ?
[68] select the average value of sensor 1 and sensor 2
select the differential measurement of sensor 1
and sensor 2
[69] select voltage input
select linear resistance input
select temperature input
[70] select Pt sensor type
select Ni sensor type
select TC sensor type
[71] select Ni50 as sensor type
select Ni100 as sensor type
select Ni120 as sensor type
select Ni1000 as sensor type
[72] select custom TC as sensor type
select TC-B as sensor type
select TC-E as sensor type
select TC-J as sensor type
select TC-K as sensor type
select TC-L as sensor type
select TC-N as sensor type
select TC-R as sensor type
select TC-S as sensor type
select TC-T as sensor type
select TC-U as sensor type
select TC-W5 as sensor type
select TC-W3 as sensor type
select TC-Lr as sensor type
[73] disable LCD error backlight
select white LCD error backlight
select red LCD error backlight
[74] apply value for the lower calibration point and
allow it to stabilise
[75] apply value for the upper calibration point and
allow it to stabilise
[76] enter PIN code for menu access
[77] select PIN code for menu access
(0000 disabled)
[78] select display unit
[79] select position of the decimal point
[80] set lower display measurement range
[81] set upper display measurement range
[82] use display scaling (overwrites the configured
monitoring view)
[100]
SW.ER
exception error during code execution
FL.ER
FLASH memory error
EE.ER
EEPROM memory error
ADC.ER
A/D converter error
RA.ER
RAM error
COM.ER
internal communication error
NEW.DEV
new device detected – configuration is
being updated – please wait
CONF.ER
configuration is being re-synchronised
– please wait
SE1.ER
error sensor 1, check the connection
and replace if necessary
SE2.ER
error sensor 2, check the connection
and replace if necessary
CJC.ER
error CJC sensor, check the connection
and replace if necessary
CJC.ER
error internal temperature sensor
CA.ER
last process calibration not successful
– please retry
IN.HI / IN.LO sensor 1 out of range
IN.HI / IN.LO sensor 2 out of range
IN.HI / IN.LO CJC sensor out of range
IN.HI / IN.LO sensor 1 or sensor 2 measurement out
of range