■
To direct wire, remove the AC input cable/plug and connect black live
wire from a branch circuit to the line side (L) of the built-in terminal
block and connect the white neutral wire to the neutral side of the
terminal block (N), as indicated on the case. This LED power supply
uses Class II AC inputs with a fully isolated case; ground wire should
not be connected.
■
Before restoring power, make sure all connections are tight and the
endcaps are reinstalled securely.
■
The 24-volt power cable to the tape lighting can be shortened or
lengthened as needed. 18AWG is recommended when lengthening
this cable; keep wire runs as short as possible. Always use suitable
wire connectors to meet installation requirements.
■
Use the optional screw-tabs for mounting securely when needed,
for example, underneath a kitchen cabinet.
MOUNTING OPTIONS
■
To surface mount the LED tape light under a set of cabinets in one
continuous run, you may need to drill a 1/2 in. hole through any
cabinet side lip that may be present. Install LED tape light through
the hole and surface mount as a continuous run.
■
For maximum light output and to focus light on the work surface,
mount the tape light 1-2 inches behind the front cabinet lip. This
mounting position works best with dull or matte fi nished countertops.
The LED tape has
a wide beam angle
■
To eliminate bright spots from highly refl ective countertops, mount
the tape light on the inside back of the cabinet lip frame facing
towards your backsplash. Because of the wide beam angle of the tape
light, this mounting position will still provide ample lighting.
Mount on inside of cabinet
lip to reduce refl ections
■
When mounting under a cabinet or a shelf with no lip to hide the LED
tape light strip, create a visual barrier using a piece of quarter round
molding or any angle trim to hide the LEDs.
Creating above cabinet uplighting
■
Most cabinet tops have uneven surfaces. To create indirect uplighting
over cabinets, simply mount the LED tape on any rigid strip (e.g.,
thin lattice or corner guard molding) and place on top of cabinets.
Angle the strip position to achieve the desired illumination.
■
For a seamless glow and to avoid bright light spots, move the LED
tape light strip further from adjacent walls.
Mount LEDs
farther from
the wall to avoid
bright spots
CEILING
OPERATION
Functions of the remote
■
Pull out the plastic battery barrier sheet from the battery
compartment located on the bottom of the remote.
■
The remote does not require line-of-sight to operate the lights. Range
will vary depending on your building structure and where the receiver
on the tape light is mounted.
■
The remote can operate up to 50 feet in optimal conitions, but each
installation has unique variables that may affect range.
Incrementally
adjust the
brightness
of the lighting
up or down.
Note: As lighting
is dimmed, the
color temperature
will change
to a warm glow
Select from
various fade
and strobe
dynamic effects
Increase
or decrease
the speed of
the selected
dynamic effect
Turns lights
ON or OFF
Brightness
settings
are saved
Quick access
to preset
light levels
3
