1. Learning (matching)
a. Do wiring according to connection diagram
b. Wake up the remote control by touching ON/OFF button.
c. Press learning button on receiver.
d. Touch any zone button on remote control.
e. Then touch color temperature wheel.
f. Connected LED light will blink to confirm zone designation.
g. Press at learning button on receiver over 5 seconds until LED light flash, then delete the learned
ID.
Note 1:
• To choose a master from slaves by jumper for each zone.
• Short circuit for master.
• Open circuit for slave.
• Each zone only can set one master controller. After a period of time, the master will do synchronization
operation to keep the same color or mode of all slaves in one zone.
Note 2:
• Each remote control 6 zones (areas) receivers, each area can be learned as many receivers as we can.
• Each receiver maximally can be controlled by 8 different remote controllers.
2. Dim wheel
Choose zone number
, for example,
and
, then touch
, choose the brightness
you want, zone 1 and 3 will indicate corresponding brightness as we touched.
3. Brightness up & Down Button
Long Press button to dim down/up brightness, the dimming direction will change every time
after pressing switch. For example, the first long press is brightness up, it will be dimmed down
when long press again.
4. Brightness level button
Select zone from
. Press , the corresponding zones will be 25% brightness. Press ,
the corresponding zones will be 50% brightness. Press , the corresponding zones will be 75%
brightness. Press , the corresponding zones will be 100% brightness.
5. Save and recall button
a. Save Color temperature
b. Recall: select zone button which we want recall from
then short press save button
oPeRatIon
SaFety & WaRnIngS
1. The product shall be installed and serviced by a qualified person.
2. IP20.Please avoid the sun and rain. When installed outdoors, please ensure it is mounted in a
water proof enclosure.
3. Always be sure to mount this unit in an area with proper ventilation to avoid overheating.
4. Please check if the output voltage of any LED power supplies used comply with the working volt-
age of the product.
5. Never connect any cables while power is on and always assure correct connections to avoid short
circuits before switching on.
6. Please ensure that the cable is secured tightly in the connector
7. For update information please consult your supplier.
