Important Notes
•
Do not remove the support bracket from
the lamp body.
•
Do not pinch or sharply bend the supply
cord while adjusting the lamp head.
•
Do not open the worklight body, there are
no user serviceable parts inside.
•
Do not immerse in water or any
other liquid.
•
Do not use abrasive cleaners,
clean with a damp cloth.
•
If the supplied flexible cord is damaged
it must only be replaced by a service
agent or similarly qualified person in order
to avoid a hazard.
High Output LED
Module Array
•
20W LED array
•
Provides high intensity even
light distribution
•
Indoor/Outdoor lighting for contractor,
tradesman, and DIY applications
•
Cool to touch durable polycarbonate/
aluminium housing
•
Wide angle coverage for large
work areas
•
Weatherproof IP44 rating.
Specifications
INPUT VOLTAGE
220-240Vac 50Hz
WATTAGE
20W
IP CLASSIFICATION IP44
LED
Super bright module
• 300mA
• 29-35V
• 20W
• 6500K
(non-replaceable type)
PROTECTIVE
SHIELD
Glass Lens
172 x 110 x 3.85mm
thick
ENCLOSURE
polycarbonate/
aluminium housing
Hold stand handle firmly
Push lamp
head forward
or backward to
desired angle
70°
even
light
beam
WLED2030 A5_ 4 pAgE instruction mAnuAL cpin002943/2
Base
stand
Opening
adjacent to
the Support
Bracket
opening
Fixing
knob
Introduction
The Arlec WLED2030 is suitable for
indoor and temporary outdoor use. It is
ideal for contractor, tradesman and DIY
handyman applications. Please note that
when used outdoors the supply plug and
socket-outlet must be suitably protected
against water ingress.
Assembly
Assemble the worklight as shown below.
1 Remove the fixing knob with integral screw
from the base stand, then slide the base
stand into the opening adjacent to the
support bracket.
2 Insert fixing knob with integral screw into
the captive nut inside base stand, then
tighten firmly.
To set the tilt of the lamp head simply loosen
the fixing knob, push the head forward
or backward to the desired position while
holding the base stand, then tighten the fixing
knob.
Note: Do not remove the support bracket from
the lamp body. While adjusting the lamp head
avoid pinching or bending of the supply cord.
Use of Worklight
1
Adjust the tilt of the lamp head by pushing
the top of head forward or backward to the
desired position while holding the stand
firmly by the handle.
2
Plug the worklight into a power point.
3
Turn on the power to the worklight.
PORTABLE WORKLIGHT
20W
PORTABLE WORKLIGHT
20W