IMpoRTANT sAfeGuARds
1
1. Read all instructions before using
this heater.
2. This heater is hot when in use. To avoid
burns, do not let bare skin touch hot
surfaces. Use handles when moving
this heater. Keep combustible material
such as drapery and other furnishings,
at least 1 metre from the heater. When
in use keep the mains cord of the heater
from touching the heater body. Do not
drape the cord over the heater while
hot. Extreme caution is necessary when
any heater is used by or near children or
invalids and whenever the heater is left
operating unattended.
3. Always unplug heater when not in use.
4. Do not operate any heater with a
damaged cord or plug or after the heater
malfunctions, has been dropped or
damaged in any manner. Return heater to
suitably qualified facility for examination,
electrical or mechanical adjustment or
repair.
5. Do not use outdoors, the product is
designed only for household use.
6. Never locate heater where it may fall
into a bathtub or other water container.
7. Do not run cord under carpeting. Do not
cover cord with throw rugs runners, or
the like. Keep cord away from traffic
areas to avoid tripping over.
8. To disconnect heater, turn controls to off,
then remove plug from outlet.
9. Connect to properly earthed socket-
outlet of the appropriate voltage.
10. Do not insert or allow foreign objects to
enter any ventilation or exhaust opening
as this may cause an electric shock or
fire, or damage the heater.
11. To prevent a possible fire, do not block
the grilles in any manner.
12. Do not use in areas where petrol, paint,
or flammable liquids are used or stored.
13. Use the heater only as described in this
manual. Any other use not recommended
by the manufacturer may cause fire,
electric shock, or injury.
14. Do not connect via double adapters
or power boards. Avoid the use of an
extension cord because the extension
cord may overheat and cause risk of fire.
However, if this heater is used with an
extension cord, use as short a cord as
practical.
15. Do not use this appliance with a
programmer, timer or any other
device that switches the heater on
automatically, since a fire risk exists if
the appliance is covered or positioned
incorrectly.
16. In order to avoid overheating, do not
cover the heater.
17. To eliminate a choking hazard for young
children, remove and safely discard the
protective cover fitted to the power plug
of this heater along with all packaging
material and promotional labels.
18. Fully unwind the cord before first
time use.
19. There are no user serviceable parts in
this heater; any maintenance other than
cleaning should be performed by an
authorised service representative.
20. The installation of a residual current
device (safety switch) is recommended
to provide additional safety protection
using electrical appliances. It is
advisable that a safety switch with a
rated residual operating current not
exceeding 30mA be installed in the
electrical circuit supplying power to
the appliance. See your electrician for
professional advice.
21. Keep these instructions handy for
future reference.
2000W METAL
CERAMIC HEATER
With AdjustAble thermostAt
And osCillAtinG FunCtion
›Osville‹
CPIN002594/2
opeRATIoN
3
poWeR coNTRol sWITch
i.
With the ON/OFF Power on switch pressed the
heater will operate at low heat setting 1200W.
ii.
When the switch marked High is pressed the
heater will operate at high heat setting 2000W.
The On/OFF switch has to pressed for the
heater to operate at high heat setting.
oscIllATIoN coNTRol sWITch
i.
When the button marked ‘SWING’ is pressed
the heater will oscillate side to side. Press the
switch again and the heater will stop
oscillating.
TheRMosTAT coNTRol
i.
The rotary knob is to regulate the heat in order
to maintain a desired temperature. When the
room temperature setting is lower than the
temperature setting on the knob, the heater
will function and heat up the room until the
desired temperature is attained. When the ambient temperature reaches the set temperature,
the heater will be turned off automatically. Turn the knob further clockwise for higher
heat setting.
opeRATING youR heATeR
cAuTIoN: There may be some odor coming from the heater for the very first time you use this
heater. This is normal during the break-in period or after long term storage. Make sure the
heater is in well ventilated area and continue running it until the smell goes away.
before first use
Remove all the packaging material along with any promotional material.
Unwind the cord to its full length and place the heater on a firm level surface in a stable, upright
position. Visually inspect the air inlets and outlets to ensure that there are no blockages.
i.
Set the power control switch to off position.
ii.
Plug the heater into a 10 Amp wall socket.
iii.
Ensure heater is on a flat stable surface. If on a carpet ensure that the carpet pile does not
obstruct the air vents on the underside of the body or cause the tip over switch to operate
inadvertently.
iv.
Press the ON/OFF button to ON position and the heater will operate at low heat setting 1200W,
press High heat setting button and the heater will operate at high heat setting 2000W.
Set power knob to desired position as given above.
v.
Turn the thermostat control knob clockwise until the heater is ON. The power on light on the
front of the heater body will illuminate. Slowly turn the thermostat control knob anti-clockwise
until the heater shuts OFF. The heater will automatically maintain this temperature.
For a lower temperature turn the knob further anti-clockwise.
For a higher temperature turn the knob clockwise.
vi.
When you want turn off the heater turn the Power On switch to OFF position
and give ample time for the heater to cool down.
NoTe:
If operated at the Low heat setting, the heater will not provide as much heat output as
in the High heat setting, however the low setting will not require as much electrical power to
operate. To avoid overloading a circuit, do not plug the heater into a circuit that already has
other appliances working. When the heater is not in use switch off and unplug.
oN/off switch
low Range heater
1200W
high Range heat (2000W)
oscillation
control button
Thermostat
control
WARNING
2
• Young children should be supervised to ensure that they do not play with the appliance.
• The heater must not be located immediately below a power outlet.
• Do not use this heater in the immediate surroundings of a bath, shower or swimming pool.
• The heater must be connected to an earthed socket-outlet of the appropriate voltage.
• The product is for household use only.
• In order to avoid overheating, do not cover the heater.
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
NoTe
: The heater is equipped with a tip over switch. If the heater is knocked over the power will
be cut off automatically.
Tilt switch
carry handle
heat panel
safety Grill
support base
control panel
CEH553_CPIN002594/2.indd 2-4
6/11/13 3:01 PM