8. Attach the front grille; unscrew the
small screw and nut attached to the
front grille. Lift the grille locking
clips attached to the rear grille, align
the screw hole on the rear and the
front grille and secure it by fastenings
the locking clips over the outer trim.
(Figure 7). Put the screw and nut back
on to the grille for additional safety.
9 Attach the speed control switch box
to the support pole using two 10mm
long machine screws supplied
separately in a poly bag. (Figure 8).
fastening knob from the pedestal
pole and pull it out. Insert the
pedestal pole screw cap and push
it down towards the base of the fan
to cover the screw heads used to
attach the pedestal pole to the base.
(Figure 2).
3. Before putting back the height
adjustment fastening knob extend
the support pole to desired height,
the support pole will be held tightly
inside the pedestal pole. If necessary,
use a pair of pliers to grasp the
support pole and pull it into position.
(Figure 3).
4. Insert the height adjustment fasten-
ing
knob and lock the
assembly by
turning it anticlockwise. (Figure 3).
5 Insert the motor housing over the
support pole and tighten the screw
attached to the motor housing
to secure the assembly. (Figure 4)
6. unscrew the rear grille fixing screws
attached to the motor face housing.
(Figure 5).
Place the rear grille in position,
ensuring the screw holes align as
shown in the figure. If this is done
correctly, the carry handle on the
rear grille will be at the top. Put back
the screws and secure the assembly.
(Figure 6).
7. Attach the fan blade over the shaft
and tighten the screw attached to
the fan blade. While doing so make
sure the screws sits against the
flat surface of the shaft and not on
the curved shaft surface. (Figure 6).
4
Figure 2
Figure 3
Figure 4
Figure 5
Figure 7
Figure 8
Figure 6
5
CPIN002509/2