6
Activate the trigger of the trigger gun (1). Always adjust the
distance and thus the pressure of the nozzle to the surface,
which is to be cleaned.
Do not cover the machine during operation or use it in a
room without adequate ventilation!
NOTE: If the machine is left or not used for 5 minutes, it must
be switched off on the start/stop switch (7) “O”:
Press the start/stop switch (7) “O”. Disconnect the electrical
plug (12) from the socket.
Shut off the water supply and activate the trigger of the
trigger gun (1) to relieve the machine of pressure.
Lock the trigger gun (1)
When releasing the trigger of the trigger gun (1), the machine
automatically stops. The machine will start again when you
re- activate the trigger gun (1)
Install indicator diagram
1. Check the Inlet Strainer for any blockage, including
packaging debris. Remove any plastic plugs from the water
inlet/outlet.
2. Attach the Gun/Extension Nozzle holder to the side of the
body.
3 Attach the Cable Holder to the side of the body
4. Attach the Handle to the front of the body with the two
included Screws.
5. Insert the High Pressure hose onto the Pressure Hose
Outlet on the back of the body.
• Insert it firmly into the body
• Press the tab toward the hose to secure it in place
6. Pull the tab at the base of the Spray Gun away from the
port. To secure the High Pressure Hose:
• Insert it firmly into the Spray Gun
• Press the tab towards the hose to secure it in place
Page 8
For technical questions, please call 1-888-866-5797.
Item 69488
Sa
Fety
Opera
ti
O
n
Maintenance
Setup
assembly
note:
For additional information regarding
the parts listed in the following pages,
refer to
Parts Lists and Assembly Diagrams
on page 16.
Some of the following assembly steps may have been performed at the factory.
1. Check the Inlet Strainer for any blockage, including
packaging debris. Remove any plastic plugs from the water
inlet/outlet.
2. Attach the Gun/Extension Nozzle holder to the side of the
body.
3. Attach the Handle to the front of the Body with the
four included Screws.
4. Thread the High Pressure Hose onto the Pressure
Hose Outlet on the back of the body.
5. Pull the tab at the base of the Spray Gun away from
the port. To secure the High Pressure Hose:
a. Insert it firmly into the Spray Gun, and
b. press the tab towards the hose to secure it in place.
a
b