Seat cushion:
Place on chair surface.
Use the fixing straps to attach.
Connect the tubeset.
Insert the mains power plug into
mains power socket.
2
1
Install seat cushion and pump
•
cells facing up
•
tubeset at front right corner
• cells horizontal across chair,
V-shape towards front
Front of chair
Back of chair
Quick start
2
3
1
•
Pump and mattress or seat
cushion installed correctly.
•
CPR control is clicked into closed
position.
•
Pump self check:
Beep - 10 seconds - beep - ready
to use.
Press Run/Standby button.
Wait until fully inflated:
Mattress overlay:
7 minutes
Mattress replacement:
15
minutes
Seat cushion:
3 minutes
WARNING
CPR control must be
visible and accessible at
all times.
Once the Wait indicator turns off,
place bed sheet on mattress and
place patient on the mattress or
seat cushion.
The default setting is Active
mode (alternating pressure).
Install mattress overlay or mattress replacement and pump
Mattress overlay:
Place on top of base mattress.
Use the 4 corner straps to secure.
Mattress replacement:
Place on bed base.
Use the 8 straps to attach to
moving parts of bed frame.
Zip the protective cover
over the mattress with
the Arjo logo at the foot
end.
Auto Logic
•
tubeset at foot end
•
CPR at head end
•
cells facing up
2
CPR unit is clicked into
closed position.
“Click”
3
Position the pump on
a horizontal surface or
hang from bed foot rail.
4
Connect the tubeset.
Insert the mains power
plug into mains power
socket.
5
Run mains power cable
along side of mattress.
Secure the flap round
the cable using the press
studs.
6
1
630937EN_01 • 06/2020 • Page 1/2
QUICK REFERENCE GUIDE - USE
Auto Logic
