001-1
1900-EN rev
. 5
Assembling the Semi-Permanent Rack
8
Post - Top Assembly
Fig. 4
000.04295
M10 X 75 HEX ZINC
000.04410
LOCKNUT M10 ZINC
000.04910
LOCKWASHER
M12 ZINC
000.04553
M12 X 30 SOCKET LOW
HEAD ZINC
PRESSURE PLATE
TRACK BRACKET
Note: The pressure plates are preassembled to the
track brackets at the factory.
1) For your convenience, make sure the assembly
complies with "Fig. 4", check for the following:
• Pressure plates are attached to the
track brackets using two M12 X 30 low
head 9 mm socket (zinc) bolts.
• Both lock washers are present on each
assembly and were placed at proper location.
• Pressure plates orientation. Plates
mate with track brackets.
2) Fasten one track bracket onto top of post, using
two M10 X 75 hex zinc bolts and corresponding
locknuts.
3) Tighten using a 17 mm socket tool or hexagonal
key. Recommended torque: 20 N·m
.
4) Repeat procedure for second post.
Post - Base Assembly (Leg)
Fig. 5
000.04410
LOCKNUT M10 ZINC
000.04350
M10 X 110 HEX ZINC
1) Place one post perpendicular with the centre of
2) Attach one “T” plate on each side of post using
two M10 X 75 hex zinc bolts and corresponding
locknuts.
3) Tighten and secure the screws with the locknut.
Use 17 mm socket tools or hexagonal keys.
4) Tighten using a 17 mm socket tool or hexagonal
key. Recommended torque: 20 N·m.
5) Install caps on both ends of leg.
6) Repeat procedure for second post.
Assembling the
Semi-Permanent Rack
