Start with this message.
The Code line is the bottom line.
The LED of the area you want to arm is off.
Enter your
PIN
code
Press
ON
What happens next depends on how your PIN
code has been programmed:
PIN code not programmed to display areas
After entering the code and pressing
ENTER
,
all disarmed areas are automatically armed and
the display returns to the beginning.
PIN code programmed to display areas
You can do one of three options:
1.
Display more areas
– lets you display the
next disarmed area in the list. Select the area
you want to arm as explained below (option 3)
or press
NEXT
again. When finished, press
ENTER.
2.
Arm all areas
- lets you arm all the areas at
once. Press the
0
button and then
ENTER
.
3
.
Arm individual areas
- lets you arm selected
area(s) one at a time. Enter the area number and
press
ENTER
for each area you want to arm.
When finished, press
ENTER
again.
When an area is armed, its LED lights up red.
A
RMING
THE
SYSTEM
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
8
ATS User’s Manual
○ ○ ○ ○
○ ○ ○ ○
○
○ ○ ○ ○
When to arm:
You arm the premises, or an area in it, when it is
unoccupied, for example at the end of the day when
everyone has gone home. Then if an unwanted event
occurs, such as someone forcing open a door, this
sets off an alarm.
The time limit to leave the premises once armed:
Once you have armed the system, you must leave
the premises (or area) within a pre-set time as oth-
erwise you will set off the alarm. The manager of
your system will infom you what this time limit is.
Normally, you will hear a beeper during the time al-
lowed to leave the building.
When you cannot arm or disarm:
You might not be authorised to arm/disarm specific
areas in the premises because:
l
Your PIN code has been programmed to arm/dis-
arm only specific areas in the premises. Make sure
you know which areas you are authorised to arm/
disarm.
l
Your alarm system might have more than
one control panel. If so, each will have been
programmed to arm/disarm only specific areas in the
premises. Make sure you use the correct keypad for
the areas you want to arm/disarm.
l
You cannot arm an area if it has a zone that is
open, such as the magnetic contacts of a door or
window. So, before arming, make sure that all doors
and windows are properly closed.
If a zone is open when you try to arm, the keypad will
beep quickly seven times and you will get the mes-
sage “Active on ...”. You must then fix the problem.
The manager of your system will tell you which
keypad(s) you can use and which area(s) you can
arm/disarm.
○ ○ ○
○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
