9
Electrical Connection for Gas Cooktop
Fit the supply cord with a standard plug for the demand
rate indicated on the rating plate or connect it directly to
the electrical mains. In the latter case, a single pole switch
must be placed between the appliance and the mains, with
a minimum opening between the contacts of 3 mm in
compliance with current safety codes (the earthing wire
must not be interrupted by the switch). The power supply
cord must be positioned so that it does not reach a tempe-
rature in excess of 50°C above room temperature at any
point.
Before making the actual connection, make sure that:
•
The fuse and electrical system can withstand the load
required by the appliance;
•
That the electrical supply system is equiped with an
efficient earth hook-up according to the norms and
regulations prescribed by law;
•
That the plug or switch is easily accessible.
N.B: Never use adaptors, shunts or the like because they
could overheat or cuase burns.
Attention: If the appliance is installed above a built-in oven,
the electrical connection for the cooktop must be
independent of that for the oven not only for safey reasons,
but also to facilitate removable of the oven in the future.
Electrical Connection
The electric cooktops are not fitted with a power supply
cord because the type of cord used depends on the
connection to the mains (see the wiring diagram below). To
connect the cable, proceed as follows:
Open the terminal box by removing the "V" screw and
taking off the cover.
F
V
1
2
3
4
5
Connect the wires as shown in the diagram.
400V 3N ~
H05RR-F 5x1.5 CEI-UNEL 35363
400V 2N ~
H05RR-F 4x1.5 CEI-UNEL 35363
230V 1N ~
H07RN-F 3x2.5 CEI-UNEL 35364
1
2
5
4
3
2
1
5
4
3
2
1
S
N
S
R
R
3
4
5
T
N
R
N
Fix the cable in place with the "F" cable clamp, close the
lid and fasten it with the "V" screw.
Technical Information
Voltage and frequency of electrical power supply:
230V 1N
~
/ 400V 3N
~
50-60Hz 7000W
This appliance complies with the following European
Economic Community directives:
-
73/23/EEC of 19/02/73 (Low Voltage) and subsequent
modifications;
-
89/336/EEC of 03/05/89 (Electromagnetic Compatibility)
and subsequent modifications;
-
93/68/EEC of 22/07/93 and subsequent modifications.
