20
GB
Programming the cooking time
!
All the cooking zones may be programmed for a
length of time between 1 and 99 minutes.
1. Switch the hotplate on and set the temperature.
2. Press the
button repeatedly until the light
corresponding to the hotplate you wish to use
illuminates.
3. Set the cooking time using the
buttons.
4. Confirm by pressing the
button.
The timer begins counting down immediately. When
the set programme has finished, a buzzer sounds for
about 10 seconds and the cooking zone switches off.
Repeat the above procedure for each hotplate you
wish to programme.
Using multiple programmes and the display
If one or more hotplates are programmed, the
display will show the data for the hotplate with the
least time remaining, and the light corresponding to
the position of the hotplate will be switched on. The
lights corresponding to the other hotplates
programmed will flash.
To display the time remaining for the other
programmed hotplates, press the
button
repeatedly. The times remaining for each hotplate
will be shown in a clockwise order, beginning with
the front left hotplate.
Changing the programme
1. Press the
button repeatedly until the time you
wish to change is shown.
2. Use the
buttons to set the new time.
3. Confirm by pressing the
button.
To cancel a programme, follow the above
instructions. When it comes to point 2, press the
buttons simultaneously. The setting will
return to zero and the display will no longer be
operating in the programme setting mode.
Control panel lock
When the hob is switched on, it is possible to lock
the oven controls to avoid accidental changes being
made to the settings (by children, during cleaning,
etc.). Press the button to lock the control panel:
the indicator light above the button will switch on.
To use any of the controls (e.g. to stop cooking),
you must switch off this function. Press the
button for a few moments, the indicator light will
switch off and the lock function will be removed.
Switching off the hob
Press the button to switch the appliance off.
If the control panel lock has been activated, the
controls will continue to be locked even after the hob
is switched on again. In order to switch the hob on
again, you must first remove the lock function.
Demo mode
It is possible to set the hob to a demonstration
mode where all the controls work normally but the
heating elements do not switch on. To activate the
demo mode the hob must be switched on, with the
control panel lock activated.
Press the button for the rear left hotplate, the
button for the front right hotplate and the
button simultaneously and hold them for three
seconds.
The display will alternate between DE and MO and
the hob will be switched off.
When the hob is switched on again it will be set to
the demo mode.
To cancel this function:
When the hob is switched on and the control
panel lock is on, press the buttons as instructed
above.
The display will alternate between RE and AL and
the hob will be switched off.
When it is next switched on, the hob will function
normally.
