5
G
B
C
onnecting
a
f
le
x
i
b
le
j
ointle
ss
s
tainle
ss
s
teel
pipe
to
a
t
h
rea
d
e
d
attac
hm
ent
Make sure that the hose and gaskets comply with
current national legislation.
To begin using the hose, remove the hose holder on
the appliance (the gas supply inlet on the appliance
is a cylindrical threaded 1/2 gas male attachment).
Perform the connection in such a way that the hose
length does not exceed a maximum of 2 metres,
making sure that the hose is not compressed and
does not come into contact with moving parts.
Ch
ec
k
ing
t
h
e
tig
h
tne
ss
o
f
t
h
e
connection
When the installation process is complete, check
the hose fittings for leaks using a soapy solution.
Never use a flame.
A
d
a
p
tin
g
to
d
i
ff
e
r
ent
t
yp
es
o
f
g
as
It is possible to adapt the appliance to a type of gas
other than the default type (this is indicated on the
rating label on the cover).
A
d
apting
t
h
e
h
o
b
Replacing the nozzles for the hob burners:
1. Remove the hob grids and slide the burners off
their seats.
2. Unscrew the nozzles using a 7 mm socket
spanner (
see figure
), and
replace them with nozzles
suited to the new type of gas
(
see Burner and nozzle
specifications table
).
3. Replace all the components
by following the above
instructions in reverse.
Adjusting the hob burners minimum setting:
1. Turn the tap to the minimum position.
2. Remove the knob and adjust the regulatory
screw, which is positioned inside or next to the tap
pin, until the flame is small but steady.
If the appliance is connected to a liquid gas
supply, the regulatory screw must be fastened as
tightly as possible:
3. While the burner is alight, quickly change the position
of the knob from minimum to maximum and vice versa
several times, checking that the flame is not
extinguished.
The hob burners do not require primary air adjustment.
After adjusting the appliance so it may be used with a
different type of gas, replace the old rating label with a
new one that corresponds to the new type of gas (these
labels are available from Authorised Technical Assistance
Centres).
Should the gas pressure used be different (or vary
slightly) from the recommended pressure, a suitable
pressure regulator must be fitted to the inlet hose in
accordance with current national regulations relating
to regulators for channelled gas.
All manuals and user guides at all-guides.com