Ariston AW120 Instructions for and use, Instructions For Installation And Use Manual, Page: 10 / 60

Instructions for installation and use
www.aristonappliances.us
Making the right choice is important. And it’s easy.
Here I’m in control
ON-OFF (Power)
To turn on the washer, press
button
L in. To turn off, press
button L again so that it is out.
Turning the appliance off
does not cancel the selected
program.
On-Off lamp -
Door lock (Status)
Lamp M flashes slowly when
the appliance is switched on
and awaiting instructions and
at the end of a cycle, indicating
that the door can be opened. It
flashes quickly when the door
should not be opened. A
steady light means the
appliance has accepted the
selected program.
Door locked lamp
The safety lamp indicates the
washing machine door is
locked to prevent it from
beeing opened accidentally.
You must wait 2 minutes for the
lamp to extinguish, before
opening it.
Easy iron
This function allows your
clothes to come out of the
machine without wrinkling,
making it much easier to iron.
You can use it with
Permanent
Press and Hand Washables
programs.
Press this button in such
programs and the wash cycle
will come to a stop on one
position
Easy iron .You can
complete the cycle by pressing
button
H again.
10
Spin speed knob
It is used to change/exclude
the spin cycle (by choosing
symbol
) of the selected
program. The maximum speed
for the four types of fabric are:
Fabric Speed
Cotton max rpm
Synthetics 800 rpm
Wool 600 rpm
Silk no
Detergent dispenser
It is divided into 3+1 sections:
1. Detergent for pre-wash;
2. Detergent for the main
cycle wash;
3. Fabric conditioner;
4. Bleach.
Temperature control knob
It is used to set the wash tem-
perature in the recommended
program table on page 11. It
also allows you to reduce the
temperature recommended for
the selected program, and
even to set a cold wash cycle.
MAX
1
2
4
3
I G L
F E H N M
A
B C D
Washer knob and Delay
start
Use this knob to select the
wash program.
Turn this knob clockwise only.
To select a program, you should
turn the knob so that the word/
number of the desired program
is in line with the pointer on the
knob.
Now press on/off button
L , pilot
lamp M will start flashing.
After 5 seconds, the setting will
be accepted, pilot lamp
M will
stop flashing (staying lit) and the
wash cycle will begin.
If you want to interrupt the
program in progress or set a new
one, select one of the
Reset
positions and wait 5 seconds .
When the cancellation has
been accepted, pilot lamp
will
flash 5 times, and you can then
turn the appliance off.
You can use this knob to delay
the appliance's operation.
Select one of the 4 delay time
positions, press the on/off
button
L in and wait 5 sec. The
setting has now been accepted
(pilot lamp
M stays lit) and you
can select the program you
desire.
Pilot lamp M has a particular
flashing motion (2 sec. on and
4 sec. off) to indicate that a
delayed start has been set.
During this phase, you can
open the appliance door and
change the washing load,
should you wish to do so.
After the wash cycle has been
set and accepted by the
washer-dryer, turning the knob
will have no effect (except for
when it is on position
Reset
(Stop).
Extra Rinse
This function adds one rinse
cycle
for Cotton and
Permanent Press fabrics.
Use of this function is
recommended for improving
rinsing results when washing
full loads and large quantities
of detergent are used.
Recommended for detergent
contact allergies.
The detergent dispenser with
the additional bleach
compartment is here.
(For details see page 15).
Knobs are hidden. Just
press them lightly in the
middle to extract them.
Program key to consult a
straightforward chart of the
different programmes availa-
ble: pull the grey tab outwards
to open it.
Pre-wash
With this button, you can pre-
wash on all programs except
the Wool program. (see page
11).
Soaking Soaking Soaking Soaking Soaking
This function allows you to leave
your washing to soak for one
hour during the wash cycle.
During this time, your washing
is also tumbled.