19504265000 English.
{PDF Created 13/11/04 11:53}
3
Dryer Description
TD4050AUSIssue 1
To open door
Press and release the front panel
in position shown.
The Features
Control Panel
The
START/CANCEL
button
starts a
selected programme. When you press this
button there will be one beep and the progress
lights will flash to confirm the action. If you
have not set a programme, the buzzer will
beep four times. When a programme is running
holding this button in cancels the programme
and stops the dryer.
(see Start and
Programmes).
The
OPTION
buttons select available options for
your selected programme.
(see Start and
Programmes).
The
OPTION
lights indicate that the option has been
selected by the button to the left of the appropriate light.
The
Drying Guide
allows you to consult a user friendly
table of fabric types and load capacities.
The
Empty Water
indicator light
signals that the water
container should be emptied. When it is flashing it indicates
that the container is full. The light will take a few seconds to
go out after replacing the empty water container; the dryer
must be running for this to happen.
(see The Controls)
The
ON/OFF
indicator light
signals that your dryer is in
use or ready to select a programme. If this light flashes it
indicates there is a fault.
(see Troubleshooting)
The
ON/OFF
button
, if the dryer is running and this
button is pressed the dryer stops. Press again the dryer
restarts.
The
Progress
or Delay
lights show you the status of the
programme or the delay time when they flash.
During a Delayed start the lights flash to show the delay
selected. When (not flashing) they show each stage of the
programme by the corresponding light turning on
(see Start
and Programmes).
The
PROGRAMMES
knob sets the programme: rotate
until the indicator is pointing to the programme you want to
select (see Start and Programmes).
GB
