2
AUS
Important Information
For your Condenser dryer to operate efficiently,
you must follow the regular maintenance
schedule shown below:
Fluff Filter You MUST Clean the fluff filter
after every drying cycle.
Step 1
Open the door of your dryer.
Step 2
Pull out the filter (using the two
finger grips).
Step 3
Open the filter by releasing the
clip.
Step 4
Clean any fluff deposits from the
inside surface of the filter mesh.
Step 5
Refit the filter Never run the
dryer without a filter.
Failure to clean the filter after every drying
cycle will affect the drying performance of your
machine It will take longer to dry and as a
result will use more electricity during drying.
Water Container You must empty the water
container after every drying cycle.
Step 1
Pull the water container
towards you and remove it fully
from the dryer.
Step 2
Empty the Water from the
Container.
Step 3
Refit the Water Container
ensuring that it is pushed fully
back into position...
Failure to empty the Water Container will result in:
- The machine will stop heating (so the load
may be wet at the end of the cycle).
- The Empty Water light will flash to tell you
that the Container is full.
The water bottle/clean
filter light comes on when
you select a programme to
remind you to make sure
that the water bottle is
empty and that the filter is
clean before starting a new
cycle
Priming the Water Collection System
When your dryer is new, the Water Container will
not collect Water until the system is primed, this
will take 1 or 2 drying cycles. Once primed it
will collect Water during every cycle.
2
Downloaded From WashingMachine-Manual.com Manuals
All manuals and user guides at all-guides.com