ARISTEL NETWORKS
PTY. LTD
Entering programming mode
Plug a telephone (SLT) into the “PHONE” socket and unplug the “LINE” connection
Lift off handset. You will hear continuous dial tone
Dial * * * * #. You will hear “Beep, Beep, Beep” repeated continuously.
The green and yellow LEDs flash. You have 10 seconds to enter the password.
Enter the password (default = 1234#)
You will hear a “Der” tone (this is “set-up” tone) repeated every 2 seconds.
The green and the yellow LEDs will slow flash.
System programming can now be commenced. See chart below.
If a feature is correctly programmed, the green and the yellow LEDs will flash
once and a Beep tone will be heard. If the input was incorrect, the green and the
yellow LEDs will flash three times and three Beep tones will be heard.
If you make an incorrect entry, hang up for less than 2 sec. to return to set-up mode
To end programming, hang-up for more than 2 sec. or press * * 0 0 #
Programming Features and Programming method
1.
Outgoing timer control
1.1
The system will give a 3 beep warning 25 seconds before the timer has been reached. This
is a warning that the call may be about to be disconnected.
1.2
Press: 9 0 x where x is the time in minutes that an outgoing call is limited to.
1.3
Press 9 1 1 to disable the auto outgoing call disconnection when the timer has expired
1.4
Press 9 1 2 to allow the auto outgoing call disconnection when the timer has expired
1.5
Press 9 0 0 to disable the timer function for outgoing calls
2.
Call Restriction
2.1
Press 9 1 5 to enable trunk selection (mobile or land-line)
2.2
Press 9 1 6 to disable trunk selection (mobile or land-line)
NOTE 1. SELECTIVE ROUTING VIA THE MOBILE LINK IS ONLY POSSIBLE IF CALL
RESTRICTION IS ENABLED.
NOTE 2. IF RESTRICTION IS ENABLED, YOU MUST ENTER ALLOWED CODES OR NO
CALLS ARE POSSIBLE.
3.
Allowed Dialling Codes
3.1
Press 8 x x x x x x x x x #
OR
(version EA or later) 80 x x x x x x x x x # to add a code
or prefix.
Up to 50 codes/prefixes can be entered.
Each code/prefix can be 9 digits max.
3.2
Press 7 x x x x x x x x x #
OR
(version EA or later) 70 x x x x x x x x x # to delete the
code or prefix
3.3
Press 9 9 8 to clear all codes/prefixes
4.
Outgoing Tone
4.1
Press 9 2 7 to disable beeping tones for GSM network calls
4.2
Press 9 2 8 to enable beeping tones for GSM network calls
5.
Polarity Reversal
5.1
Polarity reversal for outgoing calls. If the called party answers, the polarity to the phone
will be reversed. If the called party hangs up, the polarity will return to normal polarity
5.2
Polarity reversal for incoming calls. When an incoming call is answered, the polarity will
be reversed. If the calling party hangs up, the polarity will return to normal polarity
5.3
Polarity options:
5.3.1
Press 9 6 3 to disable outgoing polarity reversal
5.3.2
Press 9 6 4 to enable outgoing polarity reversal
5.3.3
Press 9 6 7 to disable incoming polarity reversal
5.3.4
Press 9 6 8 to enable incoming polarity reversal
NEOS3000A Operating manual
Ver. 1.1
March 2004 page 5
