Arista CloudVision DCA-100-CV, Quick Start Manual

Page: 13 / 46

• Manual IP Address Setup
.
• Web Access into Host via WOK .
DHCP Based IP Address Setup
Note:
The iDRAC interface shares the NIC1 physical interface but has a different MAC address. You will need
to take note of this MAC address to map the DHCP address for the iDRAC interface.
Manual IP Address Setup
Note:
Direct IP Address Setup requires a terminal connected to the VGA port of the appliance. This section can
be skipped if the Host and iDRAC IP addresses have been configured with a DHCP server.
See the Back Panel Features and Indicators for complete back panel descriptions.
IPMI IP Address
The IPMI IP address can be manually configured via the host's bash shell using the
racadm
tool. The
racadm
commands below are sequence dependent and must be entered in the following order.
1. Using the attached terminal and keyboard, log in as user using “root” with the default password of “arista”.
You should now be logged into the appliance.
2. Disable all IPMI related DHCP configurations.
racadm set iDRAC.IPv4.DHCPEnable 0
racadm set iDRAC.IPv4.DNSFromDHCP 0
racadm set iDRAC.NIC.DNSDomainFromDHCP 0
3. Configure the IP network settings for the IPMI interface.
racadm set iDRAC.NIC.Enable 1
racadm set iDRAC.IPv4.Address <iDRAC-IP>
racadm set iDRAC.IPv4.Netmask <iDRAC-MASK>
racadm set iDRAC.IPv4.Gateway <iDRAC-GW>
4. Configure the DNS settings for the IPMI interface.
racadm set iDRAC.IPv4.DNS1 <iDRAC-DNS1>
racadm set iDRAC.IPv4.DNS2 <iDRAC-DNS2>
racadm set iDRAC.NIC.DNSRacName <iDRAC-NAME>
racadm set iDRAC.NIC.DNSDomainName <iDRAC-DOMAIN.NAME>
5. Verify the configuration by running:
racadm getSysInfo
Host IP Address
The host IP address can be manually configured via the host's bash shell. In order for the settings to be persistent,
the following configuration must be done.
9
Preparation