Chapter 3
Preparation
This section describes the initial setup and preparation for installing the switch.
This chapters contains the following topics:
•
•
Tools and Parts Required for Installation
•
Electrostatic Discharge (ESD) Precautions
3.1
Site Selection
The following criteria should be considered when selecting a site to install the switch:
•
Temperature and Ventilation: For proper ventilation, install the switch where there is ample airflow
to the front and back of the switch. The ambient temperature should not go below 0° or exceed
40°C.
Note: To prevent the switch from overheating, do not operate it in an area where the
ambient temperature exceeds 40°C (104°F).
•
Rack Space: Install the switch in a rack or cabinet. The switch height is 1.74". The accessory kit
provides mounting brackets and screws required for the installation..
When mounting the switch in a partially filled rack, load the rack from bottom to top, with the
heaviest equipment at the bottom. Load the switch at the bottom if it is the only item in the rack.
•
Power Requirements: Power requirements vary by switch and power supply model. Refer to
3: Switch Specifications (Power Ratings)
and for information regarding your specific system.
Note: The power input plug-socket combination must be accessible at all times; it provides
the primary method of disconnecting power from the system.
•
Other Requirements: Select a site where liquids or objects cannot fall onto the equipment and
foreign objects are not drawn into the ventilation holes. Verify these guidelines are met:
•
Clearance areas to the front and rear panels allow for unrestricted cabling.
•
All front and rear panel indicators can be easily read.
•
Power cords can reach from the power outlet to the connector on the rear panel.
Note: All power connections must be removed to de-energize the unit.
3.2
Tools and Parts Required for Installation
Each switch provides an accessory kit that contains parts that are required to install the switch. In
addition to the accessory kit, the following tools and equipment are required to install the switch:
Additional Tools
•
Screwdriver
•
Screws or rack mounting nuts and bolts
5
