Figure 16: Earth Grounding Adapter for DCS-7050SX3-48YC8
4.2
Grounding Adapter Assembly (DCS-7050SX3-48YC8)
Use the following steps to assemble and attach a grounding assembly to the chassis before mounting
it into the rack.
Figure 17: Earth Grounding Adapter Assembly for DCS-7050SX3-48YC8
shows the exploded and
assembled views.
Note: The chassis is shown upside down in the following figure.
Figure 17: Earth Grounding Adapter Assembly for DCS-7050SX3-48YC8
1. Identify all the components to be assembled:
•
1x Grounding adapter
•
1x Grounding bracket
•
2x Flat-head screws (Phillips,M4 x 5.00 long, stainless steel)
•
2x Hex nuts (#10-32, Serrated Flange, stainless steel)
•
1x Grounding lug (Copper, 2-hole, 6 AWG, straight barrel)
2. Insert the grounding adapter through the holes in the grounding bracket.
3. Insert the ground lug on to the grounding adapter studs and fasten using the hex nuts to form the
grounding assembly.
4. With the chassis on its top on a flat surface, attach the grounding assembly to the chassis using the
flat head screws.
5. Turn the chassis over before mounting it into a rack and connecting cables.
4.3
Connecting Power Cables
This section discusses the correct procedure for connecting the power cables to the device.
Important: Installation of this equipment must comply with local and national electrical codes.
If necessary, consult with the appropriate regulatory agencies and inspection authorities to
ensure compliance.
18
