8
Electrical Connection
I
WARNING
ELECTRICAL SHOCK HAZARD.
DISCONNECT POWER BEFORE SERVICING. REPLACE ALL
PARTS AND PANELS BEFORE OPERATING. FAILURE TO DO SO
CAN RESULT IN DEATH OR ELECTRICAL SHOCK.
1.
Remove the knockout and the Junction box cover, and then
install the conduit connector (cULus listed) in the junction
box.
A
B
A. Knockout
B. Junction box cover
2.
Run 3 wires - black, white, and green - according to the
National Electrical Code and local codes and ordinances, in
1⁄2” conduit from the service panel to the junction box.
A
B
C
D
E
F
A. White wires
B. Black wires
C. CUL listed wire connector
D. Yellow-green (or bare)
ground wire
E. Homepower supply cable
F. UL listed or CSA approved 1⁄2”
strain relief
I
WARNING
ELECTRICALLY GROUND THE BLOWER. CONNECT THE
GROUND WIRE TO THE GREEN AND YELLOW GROUND WIRES
IN THE TERMINAL BOX. FAILURE TO DO SO CAN RESULT IN
DEATH OR ELECTRICAL SHOCK.
3.
Connect the black wire from the service panel to the black or
the red in the junction box. Connect the white to white and
green to green-yellow.
4.
Close and secure the junction box cover.
Complete Installation
Replace filters
Check operation of the hood.
If range hood does not operate:
• Check that the circuit breaker is not tripped or the house fuse
blown.
• Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood, read
the “Mainteinance” section.
Keep your Installation Instructions and Use and Care Guide
close to range hood for easy reference.
Description of the Hood
2
4
3
3
1
1. Blower and light controls
2. LED lamps
3. Grease filter handle
4. Grease filter
Control
1. Light On/Off button
2. Blower On/Off button
3. Blower speed minimum button
4. Blower speed medium button
5. Blower speed maximum button
NOTE:
Control buttons will light up when range hood is On.
Operating the light
The Light On/Off button (1) controls both lights. Press once for
On and again for Off.
