ARIETE 00C199420ARIT, Manual

Page: 12 / 16

EN
- 10 -
This product requires a supply hose and a regulator. Check with your gas supplier. 31.
Any modification of the appliance can be dangerous. 32.
Always close the gas cylinder valve when the appliance is not used. 33.
34. The appliance shall not be disposed with normal waste at the end of its life.
Refer to the regulation applicable in the Country where the product is marketed.
ALWAYS KEEP THESE INSTRUCTIONS
APPLIANCE DESCRIPTION (Fig. 1)
A Steel support grid
B Burner cap
C Burner ring
D Appliance body
E Commands
F Nozzle for connecting the gas hose
INSTALLATION
This appliance works with liquefied gas and it is necessary an installation that envisages the use of a
rubber hose approved for LPG according to the applicable rules. Use a hose with max length of 1.5
m, inside diameter of 8-9 mm, outside diameter of 14 mm, fixed with metallic screw clamp in stainless
steel (diameter 9-16 mm), as shown in Fig 1.
Buy the cylinder at an authorized centre, to be sure it has been checked and filled properly. Always
use a pressure regulator connected to the cylinder. Such regulator must be equipped with a fixed,
standardised calibration of 30 mbar for butane and 37 mbar for propane.
Connect the hose to the rubber support of the regulator and to the one of the device with the fixing
hose. The hose must be replaced on the expiry date. The hose can be removed to avoid a tensile or
torsion stress and must not have narrow bends or chocked points. Regularly check the wear state of
the hose and, in case of leaks, do not repair but replace it.
After installation, check whether seals are perfectly sealed by spraying a soap solution on one of
them and checking there are no bubbles.
WARNING:
DO NOT USE OPEN FLAMES.
The hose used must be compliant with the applicable safety rules. Make sure it is in good
conditions, check the expiry date and replace it regularly.
Installation and regular checking should be carried out by a skilled, authorized person.