GB-17
2. Remove the spacer, handle, and eccentric spacer from the
steering lever.
NOTE: Position the right and left handles at the same height
position.
3. Install the spacer, handle, and eccentric spacer in the
appropriate height position. Do not tighten the nut holding
the eccentric spacer.
4. Turn the eccentric spacer until the right and left handles are
the same height. Tighten nut.
ADJUSTING THE PARKING BRAKE
The parking brake might need adjustment over time and after
new brake pads have been installed.
NOTE: Be sure to check parking brake on both sides of unit
(Figure 14).
With parking brake engaged, spring length should measure
1-5/8 in. (1.14 cm) between jam nuts and trunnion. If the
measurements are not within specifications, adjust the parking
brake.
1. Engage parking brake.
2. Turn jam nuts until the spring measures 1-5/8 in. (4.14 cm).
3. Check to ensure the parking brake engages and
disengages without binding by engaging and disengaging
the parking brake several times.
4. Tighten jam nuts together.
NOTE: After installing new brake pads in calipers, they must be
burnished by driving for a short distance (about 100 feet) with the
brake on. To do this, bring parking brake lever part-way up while
driving normally (in a straight line).
PTO BELT
PTO Belt Access
1. Properly stop and park unit (See Operation on page 8).
2. Lower the mower.
3. Place seat in most rearward position.
4. Remove belt covers.
5. Place foot board in open position (Figure 15).
1. Parking Brake Lever
2. Brake Rod
3. Trunnion
4. Spring
5. Jam Nuts
Figure 14
OF3303
1-5/8-in.
(4.14 cm)
1
2
3
4
4
2
WARNING: MOVING PARTS can cut or amputate
body parts. ALWAYS wait for moving parts to stop
before performing maintenance or service.
CAUTION: DAMAGED OR WORN BELTS may result
in injury and/or damage to unit. Check belts for
excessive wear or cracks often.
1. Footboard in
open position
2. Support Frame
3. Pivot
Figure 15
1
2
3
Summary of Contents for Zoom 1844 XL
Page 23: ...GB 23...
