EN - 18
Remove Slack from Attachment
Cable
1. Stop engine, remove key and wait for all
moving parts to stop and for hot parts to
cool.
2. Disconnect spark plug wire.
3. Loosen hardware securing belt cover to
unit and remove belt cover.
IMPORTANT:
DO NOT completely remove
hardware from unit.
4. Loosen jam nut on cable adjustment
barrel, and then turn the adjustment
barrel down to shorten cable and remove
cable slack. See Figure 24.
5. With the attachment clutch disengaged,
make sure auger idler arm lightly touches
the frame. See Figure 25.
6. Tighten jam nut on cable adjustment
barrel. See Figure 24.
7. Reinstall belt cover and tighten hardware.
8. Reconnect spark plug wire.
Check Attachment Idler Arm Roller
Clearance
1. Place unit in service position and remove
bottom cover.
2. Engage attachment clutch and check
the clearance between the frame and
plastic roller on the lower end of the
attachment idler arm. Roller should be
12.7 – 22.2 mm (1/2 – 7/8") from the
frame. See Figure 26.
Figure 24
1. Attachment Clutch Cable
2. Cable Adjustment Barrel
3. Jam Nut
Figure 25
Check
position
here.
Figure 26
Measure
here.
