EN - 21
Check Belt Finger Clearance
See Figure 32.
With attachment clutch engaged, the belt
finger located opposite the belt idler must be
less than 3.2 mm (1/8") from belts, but must
not touch the belts.
To adjust belt finger:
1. Remove belt cover.
2. Loosen bolts and move belt finger to
correct position.
3. Tighten bolts and recheck belt finger
clearance.
4. Reinstall belt cover and tighten hardware.
ADJUST TRACTION DRIVE
CLUTCH
See Figure 33.
1. Stop engine, remove key and wait for all
moving parts to stop and for hot parts to
cool.
2. Disconnect spark plug wire.
3. Loosen hardware securing belt cover to
unit and remove belt cover.
IMPORTANT:
DO NOT completely remove
hardware from unit.
4. Loosen jam nut on traction cable
adjustment barrel, and then turn
adjustment barrel down to shorten cable
and remove cable slack.
5. With the traction clutch disengaged,
make sure auger idler arm lightly touches
the frame. See Figure 34.
6. Tighten jam nut on cable adjustment
barrel. See Figure 33.
7. Reinstall belt cover and tighten hardware.
8. Reconnect spark plug wire.
Figure 32
Measure here.
Figure 33
1. Traction Drive Clutch Cable
2. Cable Adjustment Barrel
3. Jam Nut
Figure 34
Check position
here.
Summary of Contents for Professional Sno-Thro Series
Page 31: ......
