Ariens Pro 28 EFI CE, Service Manual, Page: 63 / 84

EN – 62
TRACK REPLACEMENT
Remove Track
IMPORTANT:
Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Place unit in service position. See
Service Position
on
page 7.
4. Remove track drive wheel. See
Remove Track Drive
Wheel
on page 60.
5. Remove track from carriage assembly. See
Figure 148 and Figure 149.
Install Track
See Figure 150 and Figure 151.
IMPORTANT:
Tracks are directional and MUST be installed
in the orientation shown in Figure 150 and Figure 151.
1.
Install track onto carriage assembly and align with
bogie wheel(s) and track runner, if applicable.
2. Reinstall track drive wheel. See
Install Track Drive
Wheel
on page 60.
3. Return unit to operating position.
WARNING:
AVOID INJURY. Before placing unit
in service position, drain fuel from tank and fuel
system. See
Draining Fuel System
on page 7.
Make sure unit is secure and will not tip.
Figure 148
Model 926337
Figure 149
Models 926060, 926069, 926338
Figure 150
1. Track Drive Wheel
2. Bogie Wheel
3. Track Runner
1
2
3
Model 926337
Figure 151
1. Track Drive Wheel
2. Bogie Wheel
1
2
Models 926060, 926069, 926338