EN - 12
2. Locate 9/32” square hole near discharge
opening and remove 5/16” self-tapping
screw (if present). Attach belt cover
bracket at angle shown using one
1/4" x 3/4” round head square neck bolt
(item 1) and one 1/4” top lock flange hex
nut (item 4). See Figure 12.
Model 815045
1. Locate 9/32” square hole near discharge
opening and remove 5/16” self-tapping
screw (if present). Attach belt cover
bracket (item 2) at angle shown using one
1/4" x 3/4” round head square neck bolt
(item 1) and one 1/4” top lock flange hex
nut (item 4). See Figure 13.
Install Rear Blower Mount
1. From under deck install one 5/16" x 1"
hex bolt (item 11) and secure with one
5/16” hex jam nut (item 12). See
Figure 14.
Install Blower Assembly
1. Grasp the blower assembly (item 15) by
the handle and insert the front pin into the
square tube on the front corner of the
deck. Rotate the blower assembly in until
the hole in the bracket aligns with the rear
mounting stud and lower the blower over
the stud. See Figures 15 and 16.
Figure 12
9/32" Square Hole
Figure 13
9/32" Square Hole
Figure 14
Figure 15
