Ariens 939401, Owner'S/Operator'S Manual, Page: 8 / 30

EN - 8
PACKAGE CONTENTS
ASSEMBLY
Tools Required
• Pliers
• Open-end wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or adjustable wrench
• Tire gauge
Unfold Handlebar
(Figure 4)
1. Remove the lower and loosen the upper
hardware on the handlebar assembly.
2. Rotate the handlebars into operating
position.
NOTE: Be careful not to damage the cable
spring hooks when rotating handlebars
upward.
3. Install and tighten the hardware on the
handlebar assembly.
Install Discharge Chute
(Figure 5)
1. Remove mounting hardware from the
auger housing.
2. Install discharge chute over opening in
the auger housing and secure pedestal
to auger housing with hardware
removed in step 1.
ASSEMBLY
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Dropping or tipping
over boxed unit could result in
personal injury or damage to unit.
Figure 3
1. Discharge Chute
2. Chute Crank
3. Sno-Tek™ Unit
4. Literature Pack
3
2
1
4
Figure 4
1. Lower Handlebar
2. Handlebar Hardware
3. Upper Handlebar
2
3
1
Figure 5
1. Mounting Hardware
2. Discharge Chute
3. Chute Pedestal
1
3
2