GB - 12
Plan your cutting so that you always trim with the left
side of the mower pan.
Following the same pattern each time you mow the
lawn can develop ridges. Change direction in mowing
pattern (when possible) to prevent ridges.
Generally, grass should be cut at about 1-1/2" (3.8 cm)
long in the spring, and not less than 2" (5.1 cm) long in
the hot summer weather.
Lower speed at turns to prevent scuffing.
If grass is high, or if it contains a high degree of
moisture, cut it first with the mower pan set high. Cut
the grass a second time, with the mower pan set lower,
for a better distribution of clippings and a cleaner cut.
For thick, lush or heavy growth lawns do not set the
cutting height too low. Grass cut too short may die.
When the blade is set too low, the mower pan will drag
on the grass and restrict air flow, causing a reduction in
the discharge of grass clippings.
Discharge grass clippings away from borderline objects
(sidewalks, driveways, fences) when cutting grass.
Discharge grass clippings over cut grass when not
cutting borderlines. This will prevent a buildup of grass
clippings on uncut grass area.
Adjust anti-scalp wheels properly for smooth
appearance in cut.
Mow with engine set at full throttle to maintain proper
blade speed and air flow for discharge of clippings.
Ariens Dealers will provide any service or adjustments
which may be required to keep your unit operating at
peak efficiency. Should engine service be required,
contact an Ariens dealer or an authorized engine
manufacturer's service center.
SERVICE POSITION
Place unit on a flat level surface. ALWAYS stop engine
and disengage clutches. Tip up on the service bar for
ease of access during some procedures. Assure unit is
secure and will not tip over. Strap and clamp onto lift if
used.
IMPORTANT:
When unit is tipped up onto its service
bar, undrained gasoline drawn into cylinder may wash
cylinder wall and shorten engine life.
FILLING FUEL TANK
To add fuel to Fuel Tank (figure 4):
1. ALWAYS place unit in open or well ventilated
area.
2. Stop engine and allow to cool for 2 minutes.
3. Clean Fuel Cap and surrounding area to prevent
dirt from entering Fuel Tank.
4. Remove Cap.
IMPORTANT:
DO NOT use gasohol or gasoline
containing alcohol. Alcohol will cause internal parts to
deteriorate. See Engine Manual for correct type and
grade of fuel.
5. Fill fuel tank to within 1/2" (1.3 cm) below bottom
of filler neck with unleaded gasoline.
6. Replace Fuel Cap and tighten.
7. ALWAYS clean up any spilled fuel.
CAUTION:
Grass catcher components are
subject to wear, damage, and deterioration
which could expose moving parts or allow
objects to be thrown. Frequently check
components and replace with manufacturer’s
recommended parts when necessary.
SERVICE AND ADJUSTMENTS
WARNING:
ACCIDENTAL ENGINE START
UP can cause death or serious injury.
ALWAYS stop engine, remove key, wait for
moving parts to stop and remove wire from
spark plug before adjusting or servicing.
HOT SURFACES can cause death or serious
injury. DO NOT TOUCH parts which are hot
from operation. ALWAYS allow parts to cool.
ROTATING PARTS can cut off body parts.
Keep hands and feet away. Loose clothing,
long hair or scarves can get caught in rotating
parts and cause death or serious injury.
CAUTION:
Remove enough fuel so that no
spillage will occur. Remove battery to prevent
spillage of electrolyte.
WARNING:
FLAMMABLE FUEL and its
EXPLOSIVE VAPORS can result in death or
serious injury.
Handle fuel with care. ALWAYS use an
approved fuel container.
No Smoking! No Lighted Materials!
No Open Flame!
Allow engine to cool before any service.
