EN – 11
Reinstall Auger Housing
With help from a capable assistant, engage
attachment clutch lever so attachment brake will not
obstruct attachment drive pulley in step 2.
2.
Tilt auger housing rear up and lower into frame so
housing mount brackets engage mount rod.
3.
Release attachment clutch lever.
4.
Align holes in housing mount brackets with holes in
frame and reinstall two tapping screws, but DO NOT
tighten.
IMPORTANT:
Unit must be on a flat, level surface during
Check tire pressure and adjust if necessary. Refer to
Operator’s Manual for specification.
6.
Torque tapping screws installed in step 4 to
33.8 N•m – 70.1 N•m (24.9 lb-ft – 51.7 lb-ft).
7.
Loosen skid shoe hardware and adjust skid shoes.
Refer to Operator’s Manual for adjustment procedure.
8.
Reinstall attachment drive belts onto attachment
sheave.
To assist belt installation, slowly pull recoil starter handle
while gently guiding belts onto attachment sheave.
9.
Reinstall belt finger and secure with two flat steel
washers, two locking washers and two hex bolts.
Figure 12
1. Attachment Brake
2. Mount Bracket
3. Mount Rod
WARNING:
AVOID INJURY. Attachment sheave
edges are sharp. Wear thick gloves to install
belts onto attachment sheave.
Figure 13
