GB - 21
NOTE: Align handlebars by adjusting
eccentric spacer until the height of
handlebars are the same.
Forward and Reverse Speed
Adjustment
(Figure 19)
IMPORTANT: The unit should track within
2 feet (0.61 m) of a straight line for 30 feet
(9.14 m).
The travel of the steering levers may need
adjustment if:
•
The unit turns to the right or left when
both steering levers are pushed as far
forward as possible.
•
The unit turns to the right or left when
both steering levers are pulled back as
far rearward as possible.
NOTE: The side the unit turns toward
indicates that the wheel on that side is turning
slower than the other wheel. Either the wheel
that is turning faster needs to slow down or
the wheel that is turning slower needs to be
sped up to allow the unit to travel in a straight
line.
1. Determine which way the unit turns.
NOTE: The forward travel adjustment bolt
adjusts the rear travel of the steering lever.
The rear travel adjustment bolt adjusts the
forward travel of the steering lever.
2. Adjust speed by loosing jam nut and:
•
Turning adjustment bolt clockwise to
decrease steering lever travel.
•
Turning adjustment bolt counter
clockwise to increase steering lever
travel.
REPLACING PTO BELT
Remove (Figure 20)
1. Lower mower deck to the ground.
2. Remove belt covers from mower deck.
3. Hook a puller into idler hole and pull idler
arm towards outside of unit until tension
is removed from PTO belt.
Figure 18
1
3
4
5
2
1. Handlebar
2. Steering Lever
3. Mounting Hardware
4. Adjustment Holes
5. Eccentric Spacer
CAUTION: Use care when
releasing idler spring tension.
Keep body parts well away from
idler when performing this
operation.
Figure 19
3
2
1
1. Forward Travel Adjustment Bolt
2. Rear Travel Adjustment Bolt
3. Steering Lever
Summary of Contents for 915137 - 2042 Zoom XL
Page 29: ......
