GB - 19
SERVICE POSITION
Put unit into service position for easy access
to underneath the deck.
1. Place unit on a flat, level surface.
2. Remove fuel cap, place a piece of plastic
bag over the opening and tighten cap
securely.
3. Adjust handlebar forward to service
position and secure (Figure 10).
4. Tip unit
onto left side,
opposite the
discharge opening.
Make sure unit is secure and will not tip
over.
IMPORTANT:
Remove plastic from fuel cap
after unit is upright and service is complete.
HANDLEBAR HEIGHT
To adjust (Figure 11, 11a):
1. Place a hole at the bottom of the braces
over the pins on the bracket. On 911526,
use the fasteners to attach one of the
holes at the top and one of the holes at
the bottom.
SERVICE AND ADJUSTMENTS
WARNING:
AVOID INJURY. Read
and understand
Maintenance
and
Service and Adjustments
safety rules
before proceeding.
CAUTION:
Avoid fuel spills. Follow
steps below to help prevent fuel
spills. If fuel leaks into air cleaner,
replace air cleaner. ALWAYS clean
up any spilled fuel.
Figure 10
OM0215
Figure 11
Pin
Hole
OM0275
1
2
3
4
Figure 11a
1
2
4
OM0271
1. Brace
2. Handlebar
3. Support Bracket
4. Fasteners
3
911526
4
4
4
