10
ENGLISH
QL101
Maintenance
CARTRIDGE REPLACEMENT
5
7
6
1
2
3
4
To replace the cartridge, please follow these steps:
-
Turn off the water supply to the faucet at the nearest shut-off
valve .
-
Remove temperature indicator (7) and make note of its color
orientation .
-
Unscrew the set screw (6) using the hex key .
-
Remove the handle (5) .
-
Unscrew the retainer cap (4) .
-
Unscrew the retainer nut (3) .
-
Remove the old cartridge (2) .
-
Insert the new replacement cartridge (2) and ensure it is
properly seated with the two locating pins in place .
-
Install the retainer nut (3) . Do not over-tighten .
-
Install the retainer cap (4) . Do not over-tighten .
-
Install the handle (5) and secure it with the set screw (6) .
-
Insert the plastic indicator back into the handle with the colors
oriented as previously noted . Red is normally on the left .
Care and Cleaning
Your sink is manufactured with the highest grade stainless steel and will provide you many years of enjoyment with the proper care .
SINK
CABINET
Do
Do
-
After use, always rinse your sink with tap water to dilute and remove deposits .
-
Towel dry after use whenever possible to prevent water spots . Should water
spots occur, clean with a mild solution of vinegar and water followed by a
thorough rinse .
-
Use liquid soap, a general household cleaner, or a weak solution of vinegar and
water for regular cleaning .
-
Only use plastic scouring pads recommended for use in stainless steel sinks,
and only use them in the bowl of the sink . Scrub in the direction of the satin
finish lines.
-
Remove dust and dry dirt with a soft, damp cloth .
-
Clean grease, oil, paint and ink stains with isopropyl (rubbing alcohol) .
Immediately rinse with water after
stain removal .
Do not
Do not
-
Do not allow any food, detergent, soap or grease to dry or sit for extended periods
of time on the surface of the sink .
-
Never use abrasive cleaning products, as they will dull and scratch the finish.
-
Do not use scouring pads on the deck, as they will dull the finish.
-
Never use steel wool pads, as they will leave iron particles on the sink, which will
cause corrosion .
-
Never leave steel or cast iron pans in your sink for extended periods of time, as this
can cause corrosion .
-
Never use chlorine-based cleaners in your new sink, they could lead to rust spots
and discolouration . If you must use them, rinse sink thoroughly with fresh water
immediately after use . If any chemicals or glue make contact with the sink during
installation, wipe clean and rinse thoroughly with fresh water .
-
Do not allow your cabinet surface to come into contact with products such as
acetone (nail polish remover), nail polish, dry cleaning solution, lacquer thinners,
gasoline, pine oil, etc .
-
Use caution when using sharp instruments that may fall and scratch the surface .
