MicroCAM User Manual
Page 20/82
IP address:
The system accepts IPv4 and IPv6 addresses as well.
Type
: The range of IP filtering
HTTP: the settings are applied to HTTP requests
STREAM: the settings are applied to stream requests
HTTP+STREAM: the settings are applied to both HTTP and stream requests
Netmask:
Subnet mask of the IP address being added. This has to be expressed in dot-decimal,
just like the address itself. (e.g. 255.255.255.0)
After clicking the Add button, the new exception will appear in the BLOCKED/ACCEPTED
ADDRESSES table above the edit fields. The elements of the table can be removed by clicking
the check box of the row and then clicking the Remove button. The above settings (default
policy, exceptions) will not be applied until clicking the Save button.
Before clicking the Save button, make sure that all settings are configured correctly, an
incorrect setup can block the user from accessing the camera. In this case the recovery
procedure may be applied.
