y
y
Assembly Instructions
9
Step
11
b:
c:
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
H
12
11
Fit the back panel
a:
Square up the unit by
making sure that
measurement
x to x
equals y to y.
Place the small back
and large back down
onto the unit as shown,
with the white surface
facing the inside of the
unit.
Make sure that the 2
backs are pushed up
tight against each other
and that they meet in the
centre of the upright
panel’s edge.
b:
Nail around the
outside edges only of the
2 back panels and
. .
Note:
Do not
nail where the
backs meet.
Nails should be
spaced about
150mm apart.
c:
Push the nail screws
. through the back
holders and tap them
down between the small
back and large back
. and into the back
edge of the divider.
Keep tapping the nail
screws in until the
back holders dig into
the small and large back.
11
12
H
12
11
N
M
N
M
N
M
+
x
y
y
x
M
N
11
12
N
Note:
These can
also be round
12
11
Note:
If ever you need to take
the backs off to dismantle the
unit, the nail screws can be
taken out using a screwdriver.
M
N
Note:
Nails should
be spaced about
150mm apart.
