Finished
front edge
Finished
front edge
Assembly Instructions
10
Step
18
Finish preparing the
divider
Turn the divider over
To fit the rail holder ,
screw through the top
hole with screw and
into the mark hole drilled
in the divider . Make
sure that it is fitted
straight, in line with the
panel edges and then fit
another screw using
the lower hole.
Screw 2 metal dowels
into the divider .
H
H
12
P
Turn the
divider over
12
D
Step
19
Prepare the large shelf
Tap 4 wooden dowels
into the large shelf .
Insert 4 large locking
nuts into the large
shelf .
C
16
C
C
C
C
Finished
front edge
D
D
D
D
16
Fit the large shelf to
the divider
Push the large shelf
onto the divider .
Use a screwdriver to
tighten the 2 large
locking nuts fitted to
the large shelf .
Note:
Turn the large
locking nuts as far as
they will go - more than
1/2 a turn.
16
12
C
16
C
Step
20
Finished
front edge
16
16
12
A
C
A
Prepare the divider
a:
Fit 3 runners to
the divider .
The 1st screw uses
the 1st hole in from the
front of the runner.
The 2nd and 3rd screws
. use the holes that line
up with the other panel
holes.
Fit 3 hinge plates onto
the divider , making
sure that the slot is
facing towards the
finished front edge.
To fit the rail holder ,
screw through the top
hole with screw and
into the mark hole drilled
in the divider . Make
sure that it is fitted
straight, in line with the
panel edges and then fit
another screw using
the lower hole.
b:
Fit a screw into
the 2nd hole in at the top
of the runners .
Insert 2 large locking
nuts into the divider
. .
Note:
The arrow on the
locking nut
must
point
towards the hole in the
edge of the panel.
Tap 4 wooden dowels
into the divider .
Screw 3 metal dowels
into the divider .
A
12
A
H
H
P
A
12
Summary of Contents for Malvern 380/4629
Page 24: ...ALR3205...
