Assembly Instructions
10
Step
17
Fit the top
Push the top onto the
assembly.
Use a screwdriver to
tighten the 2 large lock-
ing cam nuts fitted at
the top of the left side
and right side .
Carefully turn the assem-
bly over for the next step.
Step
18
Fit the backs
a:
Square up the unit by
making sure that
measurement x:x equals
y:y.
b:
Place the 3 backs
and down onto the
unit as shown.
Make sure that the 3
backs and are
pushed up tight against
each other and that they
meet in the centre of the
upright panels’ back
edge.
Only nail around the
outside edges of the 3
backs and .
c:
Using 12 screws ,
screw down between the
3 backs and and
into the upright panels’
back edge.
Carefully stand the unit
up for the next step.
3
3
D
1
2
1
2
H
c:
H
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
G
b:
10
9
10
9
10
9
10
9
10
G
H
9
10
x 6
H
x 6
y
y
x
x
Finished
front edge
Warning:
The
unit is heavy.
Lift with care.
Warning:
The
unit is heavy.
Lift with care.
Note: Do not nail
where the backs
meet. Nails
should be spaced
about 150mm
apart.
Note: The middle back is
294mm wide and the other
2 backs are 300mm wide.
9
9
www.youtube.com/watch?v=udEKmXmPEW0
Squaring up a Robe and fitting the Back Panel
