y
y
Assembly Instructions
11
Step
19
Step
20
Fit the back
a:
Square up the unit by
making sure that
measurement
x to x
equals y to y.
b:
Place the back
onto the unit.
Nail around the 3
outside edges of the
back , as shown
Note:
Nails should be
spaced about 150mm
apart.
Stand the unit up for
the next step.
14
E
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
14
Warning:
The
unit is heavy.
Lift with care.
The gap at this end is
for cable management
y
y
x
x
x
x
b:
E
Fit the drawer
Slide both the runners
forward and locate the
drawer sides and
between them, lining up
the holes in the drawer
wrap with the 2nd
'threaded' holes in the
runners .
Working from the inside
of the drawer, insert 2
screws through the
drawer sides and out into
the 2nd threaded hole in
the runner.
Note:
Do not overtighten
the screws .
If they catch on the
runner you may need to
loosen them slightly.
J
J
O
O
2nd threaded
hole
O
J
9
10
J
J
9
10
14
