4
T T - 3 M a n u a l
7. 33/45 RPM Switch (33/off/45):
Select 33 or 45 rpm for playing a vinyl, switch to
“OFF” to pause
the playing. Switch to 33 or 45 again, to continue the playing
from the pause point.
8. Signal Connectors
Plug in the RCA cable, and connect the cable to audio amplifier.
9. Ground Terminal
Connect a ground wire.
10. Power supply jack:
Plug-in DV12/0.5A switching adaptor for power supply.
11.
Power Switch
Turntable Platter and Belt Setup
1. Install the drive belt over the inner ring under the platter and
make sure it won’t fall off during the
setup.
2. Place the platter through the turntable
spindle, then rotate the platter until you
see the drive motor pulley through the
window at the top left corner.
3. Carefully grab the drive belt and put it
around the slot of motor pulley.
4. Connect the power adapter to the turntable and power on the
turntable. Set the speed to either 33 or 45. If the platter does not
spin, try the steps listed above again.
5. Remember to place the rubber slip mat on the platter before
playing records.