w w w . a r g o n a u d i o . c o m 8
TT- 2
Connecting to a Computer
Connect the USB-output of the unit to a free USB-socket on your computer and turn it on/make sure it is powered on.
The “new hardware found assistant“ will automatically detect the unit and announces it as a Microphone USB audio codec. There
is no need to install a driver manually.
After installation, one setting has to be done. For example - Windows 7® operating system:
Control Panel
Sound
Recording
Microphone USB Audio CODEC
Properties
Advanced: set to 2
channel, 16 bit, 48000 Hz (DVD Quality)
Please note: Connection should be made to a USB-socket of your
computer directly. Connecting to USB-hubs or switches can cause problems.
Recording Programme
In case you do not have a recording programme installed on your computer, you may download one free from the
Internet. Recording programmes may be found by searching Google.
In the menu of the recording programme,
source or input may have to be set to
Microphone USB audio codec.
Please be aware that downloads from the Internet are made entirely at your own risk. Under no circumstances can
we carry responsibility or provide support for third-party software products sourced from the internet or for any
damage or problems arising from the use thereof. All downloads should be checked with an up-to-date anti-virus
programme. License fees may be applicable.
Mains power connection
The turntable is supplied with a power supply suitable for your country's mains supply. Check the label before connecting to
ensure compliance with the mains rating in your house.
Connect the low voltage plug from the power supply to the socket (13) on the rear of the record player before connecting the power
supply to the mains.
Fitting the lid
Fit the lid carefully over the hinge fasteners and adjust the screws (14) until the lid stays open where you want it to without being
too stiff to open or close.
Switching on and off
Pressing the power switch (1) alternately starts or stops the motor.